Special Offer 15% off. While stocks last.

First come basis. There has been a lot more work than I intended but I wanted to make them much better and stronger than the standard weak ones.

These are not cast, but machined from solid Aluminium. But have Reamed the hole for the pivot pin and all the shapes and threads done, also includes the Stainless Steel adjusting screw fitted.
So are solid with the adjuster going through solid High Quality Aluminium. I also do the Trigger pins and Larger Detent plus other special parts.

Custoers Reply on fitting below. See last photo to see, Joes Trigger fitted.

Felt in the mood once I’d polished it up, so decided to fit it.Results are very good, I’ve managed to get it set to break cleanly, it wasn’t bad before, however, the issue with my Mk1 was the safety slide “nib” had worn slightly so was intermittent at best in use, but with the new one, the safety works perfectly again.

Other than that, a doddle to fit, I like the slightly wider blade, and definitely more solid.

Thanks ever so much. Very pleased.

All the best
Joe. Thanks Joe for letting me know.

Feinwerkbau Sport 8mm thick may need a little diy finish. Specially made High quality Aluminium Trigger (see photo left, Early plastic one on the right Mk 1), as the standard ones would  break, The Mark 1 had a plastic trigger (the one on the right, my one is on the left) and the Mark 2 had a weak hollow mazak alloy one. This trigger will fit both models.
Offered as shown for home or gunsmith finishing at the base price shown above. I have already polished the finger curve.
The holes for the spring has been done and the sides milled or filed, so would need very little work if they don't work already See Joes reply above.
There is a lot of work in making these.
But they may still a little fettling. I have sold quite a few now and not even had anybody phone asking me how to do it.
If you want to collect from the shop (when open) then let me know so I can have one ready and £5.00 off.
I also have the two springs and trigger pivot pin if required. See drop down menu where there is also the option of having the blade curve polished.
Open normally Wednesdays 10.30 till 3.30 pm.