Sheridan Bolt Probe in Stainless Steel Fraction longer Nose
Sheridan Bolt probe Lug and Straight Handle in Stainless Steel with fraction longer Nose so you can tune for more Accuracy and Power.
The Pellet position depends on what pellet you use. The Sheridan was designed to use the Sheridan Bantam 5s pellet that was more bullet shaped with a very small hollow base. So when you use a wasted type pellet with a larger hollow base then the pellet may not be pushed forward far enough to meet the rifling and clear the Transfer port.
I have designed the rear of the bolt probe to also be a bit longer to accommodate the screw in straight handle.
If you want to put a bend on the handle then you would have to tighten into the Bolt probe and mark the position with a Sharpe or similar to mark where you want the bend. I normally use lead jaws so as not to mark the handle.
Does not come with spring and ball, but I could add them if there is enough interest.
I have put some photos on where I have bent the handle to look similar to the standard but is obviously larger. I use lead vice jaws so you could do the same so you get the bend as you like it.