SMK 501 + 78 Special tool for removing the valve body.

501 Stl

£24.97 inc. tax

SMK 501 + 78 Special tool for removing the valve body.

Add to Cart

Add To Wishlist

SMK 501 + 78 Special tool for removing the valve body. Summary

SMK 501 + 78 Special tool for removing the valve body.

Special tool made for removing the Piercer Body on the XS T 501 can also be used on the 78. This allows you to remove the Piercer body easier without damaging the piercer body because it fits the SPECIALLY slotted groove exactly. A screw driver cannot be used as a bodge like the 78s. We can also supply an even longer one for those of you who have our extended Reservoir, I can make specially if required just let me know.
Now also named Rabbit Destroyer.

Make sure the gun is empty of Co2 and is not loaded.
Remove the front cap and tip out any bottles (if any) to gain access to the piercer body. Place the tool down into the reservoir until it engages in the wide slot of the piercer body. Pressing firmly down unscrew the body anti clock wise five turns or until it disengages the brass valve body.
You will not be able to remove the Piercer body from the front without undoing the reservoir tube so the tool does not need to be long like it does for the 78.
Check the valve seat is clean and clear from debris, and also the valve face. If the gun has been leaking out into the barrel then replace the valve (if it is our one you can change just the seal), the standard valve seal cannot be replaced because it is pressed together.
Now the important bit: When you want to replace the exhaust valve, DO NOT DROP IT BACK IN, but hold the gun horizontal and place the valve in the front, tilt the gun up a little at a time until the valve gradually drops back to the brass valve seat without dropping onto the seal face (because it would dent it and cause a leak even with a new seal). Look down and wiggle the res until the valve drops into the valve hole and seat. Place the valve, spring and piercer into my piercer body and holding the gun horizontal place it into the front of the res. The place the special tool in the front and gradually push to the rear until it touches the brass valve body. You can then keep the pressure on to engage the brass thread and tighten the piercer body.
Then replace the front cap or put one empty Co2 bottle in and then a live one to test for leaks. You will obviously only get half the shots with one bottle.

Brand:

T R Robb

Product Condition:

New

Updating Order Details

Please do not refresh or navigate away from the page!

Shopping Basket

items 0

Price £0.00

Checkout

SMK 501 + 78 Special tool for removing the valve body.

SMK 501 + 78 Special tool for removing the valve body.

Modal Dialog Title